2 Enable acme.sh log

neil edited this page 2017-04-26 13:42:32 +08:00

Table of Contents

• 1. You can use --log parameter in any command to enable log file.
• 2. Set the log file path.
• 3. You can also specify log level.

1. You can use --log parameter in any command to enable log file.

Once enabled, the log will take effect for any operations in future.

Example: install and enable log.

acme.sh --install    --log

If you forget to enable log when installing, you can enable log by any command. Example: enable log when issuing a cert:

acme.sh  --issue  ....   --log

2. Set the log file path.

The default log file is in ~/.acme.sh/acme.sh.log

And you can specify a log file path

acme.sh  --issue .....   --log  "/path/to/mylog.log"

3. You can also specify log level.

The default log level is 1, it will output the log info same as --debug This is enough for most cases. You can also specify log level.

set log level to 2

acme.sh  --issue  .....  --log     --log-level 2

Buy me a beer, Donate to acme.sh if it saves your time. Your donation makes acme.sh better: https://donate.acme.sh/

如果 acme.sh 帮你节省了时间,请考虑赏我一杯啤酒🍺, 捐助: https://donate.acme.sh/ 你的支持将会使得 acme.sh 越来越好. 感谢